rotazione tablet trekstor wintron
salve, dopo aggiornamento a w10 ho avuto un enormità di problemi legati ai driver non più compatibili con il nuovo sistema operativo. il più fastidioso è la rotazione automatica schermo, prima lo schermo ruotava al contrario ora ho aggiornato i driver ma gira sempre al contrario ma in modo diverso (se lo tengo verticale va in orizzontale e al contrario) cosa posso fare?
Pubblicità
Re: rotazione tablet trekstor wintron
ho trovato questo ma non ho idea su cosa fare
Known Issue(s):
===============
There’s a problem where the screen orientation is wrong momentarily after coming out of S3 or S4.
Troubleshooting:
================
If the screen does not rotate properly, you may need to adjust the chip mount configuration. This can be done with the factory_cal tool or by editing the registry.
OPTION 1:
To use factory_cal, lay the device flat with the screen facing up and run “factory_cal –mount 2” for MAP2, replace with needed map.
OPTION 2:
The “ChipMount” value in the registry is found in device key HLKM\SYSTEM\CurrentControlSet\Enum\ROOT\SENSOR\0000\kxfusion
If device does not have chip mount info (an ACPI _CDM method), please calibrate with factory_cal or set a ChipMount value in the registry.
If the screen is rotated by 90 degrees and it changes the right way when the device is turned (screen goes counterclockwise when device goes clockwise), use DEVICE_MAP2 if the screen is counterclockwise, or DEVICE_MAP4 is it’s clockwise.
If the screen changes the wrong way (rotates the same way as the device), use DEVICE_MAP6 for counter, DEVICE_MAP8 for clockwise.
Known Issue(s):
===============
There’s a problem where the screen orientation is wrong momentarily after coming out of S3 or S4.
Troubleshooting:
================
If the screen does not rotate properly, you may need to adjust the chip mount configuration. This can be done with the factory_cal tool or by editing the registry.
OPTION 1:
To use factory_cal, lay the device flat with the screen facing up and run “factory_cal –mount 2” for MAP2, replace with needed map.
OPTION 2:
The “ChipMount” value in the registry is found in device key HLKM\SYSTEM\CurrentControlSet\Enum\ROOT\SENSOR\0000\kxfusion
If device does not have chip mount info (an ACPI _CDM method), please calibrate with factory_cal or set a ChipMount value in the registry.
If the screen is rotated by 90 degrees and it changes the right way when the device is turned (screen goes counterclockwise when device goes clockwise), use DEVICE_MAP2 if the screen is counterclockwise, or DEVICE_MAP4 is it’s clockwise.
If the screen changes the wrong way (rotates the same way as the device), use DEVICE_MAP6 for counter, DEVICE_MAP8 for clockwise.